Quick answer: How to use trim command in autocad 2007?

1. Click on the TRIM icon.
2. Select the vertical and horizontal lines and press ENTER on your keyboard.
3. Select the two red parts shown on the image in step 2 on the image above.
4. Press ENTER on your keyboard when you are done.

You asked, how do I use TRIM command in AutoCAD?

1. First, select the objects you want to trim.
2. Right click on the blank space to finalize the selection.
3. Left click on the lines to trim them.

Also know, how do I cut a line in AutoCAD 2007?

Considering this, how do I trim in AutoCAD 2008?

1. Click Home tab Modify panel Trim. Find.
2. Select the objects to serve as cutting edges. Press Enter when you finish selecting the cutting edges.
3. Select the objects to trim and press Enter a second time when you finish selecting the objects to trim.

Amazingly, how do I quick trim in AutoCAD? Quick Mode. To trim objects, select the objects to be trimmed individually, press and drag to start a freehand selection path, or pick two empty locations to specify a crossing Fence. All objects automatically act as cutting edges. Selected objects that can’t be trimmed are deleted instead.The TRIM command enables the operating system (OS) to preemptively notify the SSD which data pages in a particular block can be erased, allowing the SSD’s controller to more efficiently manage the storage space available for data.

Why trim is not working in AutoCAD?

Check if the PICKADD variable is set to 2. If not you should set it to 2. Pre-select the elements and then call the TRIM command. Enter TRIM Command once in the command line and then hit enter again before using the TRIM.

How do I fillet in AutoCAD 2007?

1. Click on the fillet command icon.
2. Type R and Press Enter.
3. Specify the fillet Radius and Press Enter.
4. Select the first line.
5. Select the second line.

What is the modifying command that can be used to trim a part of an object?

The Trim command can be used to trim a part of an object.

How do I change trim and extends in AutoCAD?

Which are the steps to be followed to trim the object?

1. Select cutting edges. Specifies one or more objects to be used as a boundary for the trim.
2. Object to Trim. Specifies the object to trim.
3. Shift-Select to Extend. Extends the selected objects rather than trimming them.
4. Fence. Selects all objects that cross the selection fence.
5. Crossing.
6. Project.
7. Edge.
8. Erase.

How do I trim an Array in AutoCAD?

To unlock them, you can simply use the explode command. Or you can also edit the arrayed object by using “edit source” option under the Array ribbon.

When using the TRIM command what is to be selected first?

Right Answer is: A Step 1: Select the Trim icon from the Modify toolbar. Step 2: When prompted to Select cutting edges, press . This will make every entity a cutting edge. Step 3: When prompted to select the object to trim, pick the object to be trimmed on the side of the cutting edge you want to trim to.

How do you remove unwanted lines in AutoCAD?

Solution: To resolve the issue, try out the following: Disable Smooth Line Display. On the command line in AutoCAD, type LINESMOOTHING and set it to Off or 0 (zero).

How do I delete part of a line in AutoCAD?

Draw your polyline, rectangle or polygon or whatever. When modifying hold down the CTRL Key (just the segment will highlight) select it and Press the Delete key on the keyboard.

How do I extend a line in AutoCAD 2007?