Contents
Can’t fully define sketch in Solidworks?
In some sketches only certain relations and dimensions can fully define the sketch. Limiting your selection may prevent the sketch from being fully defined. In this sketch, no relations were allowed. It cannot be fully defined.
What is a fully defined sketch in Solidworks?
The Fully Define Sketch tool calculates which dimensions and relations are required to fully define under defined sketches or selected sketch entities. You can access Fully Define Sketch at any point and with any combination of dimensions and relations already added.
How do I fix a sketch in Solidworks?
To open the Repair Sketch tool: Click Tools > Sketch Tools > Repair Sketch. Repair Sketch deletes these from the sketch.
How can we confirm that a sketch is fully defined solidworks?
You can use the Fully Define Sketch PropertyManager to apply dimensions and relations calculated by SOLIDWORKS to automatically fully define the sketch. Click the Fully Define Sketch button from the Dimensions/Relations toolbar or pull down the Tools menu and pick Dimensions > Fully Define Sketch.
Which choice is an example of a sketched feature?
Sketched features require the use of a sketch in order to be created, and include features such as Extruded Boss/Cut, Revolved Boss/Cut and many others. Applied features do not require a sketch, and are applied directly to existing geometry.
What do blue lines mean in Solidworks?
b) Blue line is under defined because it’s free from its position and no dimension given to it. This line normally not locked and drag able.
How do I move a full defined part in Solidworks?
Click Move Component (Assembly toolbar) or Tools > Component > Move. The Move Component PropertyManager appears, and the pointer changes to . Select one or more components in the graphics area. Select a component and drag in any direction.
How do you constrain in Solidworks?
To define assembly constraints: Under Tolerance Assembly, select a part to constrain in the simplified assembly. For example, in the following two-part assembly, you selected the part with a boss as Base part in Assembly Sequence. Select the hole plate part to constrain it.
Can open sketch be extruded in Solidworks?
To use an open profile sketch to extrude using existing model edges: Open a sketch on a model face. Sketch an open profile with endpoints that are coincident with model edges on the same face boundary. Click Tools > Sketch Tools > Close Sketch to Model.
How should the warning shown here be repaired?
How should the warning shown here be repaired? Select a new face or plane to replace the missing one.
How many dimensions are required to fully define a rectangle?
A rectangle is defined as having two sets of parallel lines (4 lines total) creating 90 degree angles at each corner. This constraint in turns fully defines the sketch: therefore the rectangle can only have a length and a width (2 dimensions).
What is rollback in Solidworks?
You can use the FeatureManager rollback bar or shortcut menu to temporarily roll back to an earlier state, to absorbed features, roll forward, roll to previous, or roll to the end of the FeatureManager design tree. You can add new features or edit existing features while the model is in the rolled-back state.
How do you add a derived sketch in Solidworks?
Select the sketch from which you want to derive a new sketch. Hold the Ctrl key and click the face on which you want to place the new sketch. Click Insert > Derived Sketch. The sketch appears on the plane of the selected face, and the status line indicates that you are editing the sketch.
What is a base feature in Solidworks?
The first feature you create in a part is the base. This feature is the basis on which you create the other features. The base feature can be an extrusion, a revolve, a sweep, a loft, thickening of a surface, or a sheet metal flange. However, most base features are extrusions.
Which of the following signify that a sketch is fully defined?
Which of the following signify that a sketch is fully defined? All lines are black. If you select a face to draw a sketch, the sketch entities cannot extend beyond the edges of that face.