Contents
How do I change the length of a chord in Solidworks?
Select dimension on the toolbar. Whilst holding CTRL down, select the 2 end points of the arc and then the arc itself, let go of CTRL and then place your arc/chord dimension.
How do you show dimensions in Solidworks drawing?
Go to Tools > Options and in the Document Properties tab, click Detailing. Select Dimensions marked for drawing under Auto insert on view creation.
What is the dimension of arc?
The Arc Length Dimension tool measures and dimensions the length of an arc anywhere along its circumference. The dimension can be shown with its witness lines perpendicular to a chord on the arc, or perpendicular to a line tangent to the arc.
What is required for a tangent arc?
When an arc is tangent to a circle, its center must be the radius distance away from that circle.
How do you measure the length of a spline in Solidworks?
Select the spline to dimension. Click Smart Dimension (Dimensions/Relations toolbar) or Tools > Dimensions > Smart Dimensions.
To bring back any hidden dimension or annotation in your drawing, you’ll need to activate the Hide/Show Annotation command found under View > Hide/Show > Annotations. First, let’s hide some dimensions. If you select one or more dimensions, you can Right Click on a dimension and select Hide.
How do I see the size of a part in Solidworks?
To re-display the dimensions, right-click the feature or one of its faces, and select Show All Dimensions. To show dimension names, click View > Hide/Show > Dimension Names or Hide/Show Items > View Dimension Names (Heads-up View toolbar).
What is the chord of an arc?
A chord of a circle is a straight line segment whose endpoints both lie on a circular arc. The infinite line extension of a chord is a secant line, or just secant.
What is the dimension of angle?
Angle is defined as the ratio of length of arc to radius. Substituting in the above formula we get, Dimensional formula of Angle = M0L0T0. We can also say Angle is dimensionless quantity.
How do you find the arc length in Inventor?
You can add a dimension annotation in an Inventor drawing to give the length of your arc using the ‘General Dimension’ tool. Inventor will automatically pick the radius of the Arc. Just right click to get the ‘Length’ option.
Which end condition extruded boss?
The default end condition is “blind,” which means we will take our sketch and extrude it a set distance from the sketch plane. After that distance is met, extrusion will stop. So the condition for ending the extrusion is that it will proceed a set distance and then stop. Again, this is known as a “blind” end condition.
What type of arc can be transitioned to directly from sketching a line?
You can transition from sketching a line to sketching a tangent arc without selecting the Tangent Arc tool by autotransitioning .
How many ways can an arc be tangent to one line?
Two non-parallel lines can have only one tangent on each line using an arc of a specific radii. If there is a specific arc size, there can be as many as two ways the arc can be tangent to the line. Finally, an arc of a specific radii can be tangent to two other arcs in two places on each arc.
How do you measure a spline?
To dimension a spline, you must dimension its endpoints. You need not add spline dimensions if the spline is attached to other geometry and the endpoints are dimensioned. You can dimension spline endpoints using linear dimensions, tangency (angular) dimensions, and radius-of-curvature dimensions.
How do I run a spline in Solidworks?
First, the tool can be found under Tools > Sketch Entities > Spline. Under this dropdown you will also see a “Spline Tools” menu, we will get to those tools later. Similar to a line, you will click to define which locations in space you want the spline to pass through.
